JEONGWOOD TSA-500, Инструкция по эксплуатации

Страница: 5 / 13

16. If welding result is not so strong, push “PGM” key and “SIN”
key. When “%” and “HEAT1” lamp are on, increase previously set
figure “40” into “45”.
17. Push “RUN” key and proceed welding by press of foot pedal.
18. If welding result is still not so strong, please proceed “item 16 and
item 17” repeatedly and increase figure setting.
19. When you push “PGM” key and lamps are on at “∽” & “HEAT1”, you
may use “ ⇧ ” and “ ⇩ ” key to set figure into “2” or “3” instead of
“1”.(Ref. To item 4) However, nickel tags may be oxidized into dark if
you set at “3” or higher figure. So, you are requested to set it “1” or
“2”.
Before shipment, we did weld test and welding condition is properly set
for your immediate use. If this setting is acceptable, you can use the
welder without any further adjustment.
- 5 -