JEONGWOOD TSA-500, Инструкция по эксплуатации

Страница: 13 / 13

5) In order to weld 0.2 – 0.3mm(T) material, please see as below.
SQEZ ≒ 3 : Start to weld after 48ms
UPSL ≒ 1 : Current increasing in 16ms
HEAT1 ≒ 30 : 30% output in 2 CYCLE(32ms)
COOL ≒ 1 : Cooling in 16ms
HEAT2 ≒ 40 : 40% output in 3 CYCLE(48ms)
Weld Transformer Selector Switch ≒ level 1
Weld Pressure ≒ 7 – 10Kg
SQEZ : Time until electrode touches on material and flow weld current.
(1 CYCLE = 16ms)
UPSL : Pre-heating time of material.
HEAT1 : Heating energy to melt material.(1
st
) Current(upper line) is showing by % and
CYCLE(lower line : Time to flow current) is showing by ∽.
COOL1 : Cooling time between HEAT1 and HEAT2.
HEAT2 : Heating energy to melt material.(2
nd
) Current(upper line) is showing by % and
CYCLE(lower line : Time to flow current) is showing by ∽.
COOL2 : Cooling time between HEAT2 and HEAT3.
HEAT3 : Heating energy to melt material.(3
rd
) Current(upper line) is showing by % and
CYCLE(lower line : Time to flow current) is showing by ∽.
DNSL : After-heating time of material.
HOLD : Standby time on weld output.
※ HEAT1 for ordinary use. Thick or plated material, use HEAT2 and HEAT3 along
with COOL1 and COOL2.
※ When use HEAT1 only, set figure of time into “0” for COOL1 – HOLD.
- 13 -