JEONGWOOD TSA-500, Инструкция по эксплуатации

Страница: 4 / 13

3. Setting method of TSA-500 Spot Welding Machine
1. Turn “on” power and push “PGM” key.
2. When lamp is on at “SQEZ” and “ ≃ ”,
use “ ⇧ ” and “ ⇩ ” key to set figure into “0”
3. When “UPSL” lamp is on by push “ ⇨ ” key,
use “ ⇧ ” and “ ⇩ ” key to set figure into “0”
4. When HEAT1 lamp is on by push “ ⇨ ” key,
use “ ⇧ ” and “ ⇩ ” key to set figure into “1”
5. When COOL1 lamp is on by push “ ⇨ ” key,
use “ ⇧ ” and “ ⇩ ” key to set figure into “0”
6. When HEAT2 lamp is on by push “ ⇨ ” key,
use “ ⇧ ” and “ ⇩ ” key to set figure into “0”
7. When COOL2 lamp is on by push “ ⇨ ” key,
use “ ⇧ ” and “ ⇩ ” key to set figure into “0”
8. When HEAT3 lamp is on by push “ ⇨ ” key,
use “ ⇧ ” and “ ⇩ ” key to set figure into “0”
9. When DNSL lamp is on by push “ ⇨ ” key,
use “ ⇧ ” and “ ⇩ ” key to set figure into “0”
10.When HOLD lamp is on by push “ ⇨ ” key,
use “ ⇧ ” and “ ⇩ ” key to set figure into “0”
11.When OFF lamp is on by push “ ⇨ ” key,
use “ ⇧ ” and “ ⇩ ” key to set figure into “0”
12.When HEAT1 and % lamp are on by push “ ⇨ ” key,
use “ ⇧ ” and “ ⇩ ” key to set figure into “40”
13.When HEAT2 lamp is on by push “ ⇨ ” key,
use “ ⇧ ” and “ ⇩ ” key to set figure into “0”
14.When HEAT3 lamp is on by push “ ⇨ ” key,
use “ ⇧ ” and “ ⇩ ” key to set figure into “0”
15.When all above process are completed, push “RUN” key and
“RUN”/“SIN” /“WON” lamps are on. Then, feed battery and nickel tag
on right place and press foot pedal to proceed welding.
- 4 -