JRV215N
38
TROUBLESHOOTING
Symptom
Cause
Solution
No power
The vehicle
’s ignition is not on
If the power supply is properly connected to the vehicle
accessory terminal, switch the ignition key to
“ACC”.
The fuse is blown
Replace the fuse.
Disc cannot be loaded or
ejected
Presence of disc inside the player
Remove the disc in the player and insert the new one.
Inserting the disc in reverse direction
Insert the compact disc with the label facing upward.
Compact disc is extremely dirty or
disc is defective
Clean the disc or try to play a new one.
Temperature inside the vehicle is too
high
Wait until the ambient temperature returns to normal.
Condensation
Leave the player off for an hour or so, then try again.
No sound
Volume is too slow
Adjust volume to audible level.
Fader is set incorrectly
Access Audio Setting menu to adjust Fader settings.
Wiring is not properly connected
Check wiring connections.
Mute is on or Camera Mic is active in
camera mode.
Turn Mute Off or Turn Mic Off in camera mode.
The operation keys do not
work
The built-in microcomputer is not
operating properly due to noise
Press the
RESET
button.
Sound skips
The installation angle is more than 30
degrees.
Adjust the installation angle to less than 30 degrees.
The disc is dirty or defective.
Clean the disc and try to play again or use new disc.
Cannot tune to radio
station, auto-seek does not
work
The antenna cable is not connected
Insert the antenna cable firmly.
The signals are too weak.
Select a station manually.
Radio automatically
switches to WB (Weather
Band)
This is a normal function. A Weather
Band warning is being received.
If you do not want this to occur, set the WB Alert setting
to “Off” in the System Setup menu.
Radio automatically turns
on (ignition on) and tunes
to WB (Weather Band)
This is a normal function when the
Alert Power feature is set to “On” in the
System Setup menu. A Weather
Band warning is being received.
If you do not want this to occur, set the Alert Power
setting to
“Off” in the System Setup menu.
Radio mutes audio when
vehicle is in reverse gear.
It is a normal function for the audio to
mute when the vehicle is backing up.
If the camera has a microphone, the camera audio will be
played when in reverse gear.