Jensen JMC-1250, Руководство пользователя

Страница: 9 / 23

E-8
BATTERY INSTALLATION
The battery compartment is located on the
back of the remote control.
1. Remove the battery compartment door
by pressing in on the tab and lifting it off.
2. Insert two AAA size batteries (not
included) into the battery compartment
following the polarity markings inside the
battery compartment.
3. Replace the battery compartment door.
BATTERY WARNING
1
.
Be sure that the batteries are installed correctly. Wrong polarity may damage
the unit.
2. Use only the size and type of batteries specified.
3. Do not mix old and new batteries.
4. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium)
batteries.
5. If the unit is not to be used for an extended period of time, remove the batteries.
Old or leaking batteries can cause damage to the unit and may void the
warranty.
6. Do not try to recharge batteries not intended to be recharged; they can
overheat and rupture. (Follow battery manufacturer’s directions).
7. Do not dispose of batteries in fire, batteries may leak or explode.
GETTING STARTED
1. Connect the speaker wires to the speaker terminals (#36) located on the back
of the unit.
2. Plug the AC POWER CORD (#39) into a 120V AC ~ 60Hz outlet.
3. The unit will go into standby mode. The STANDBY LED INDICATOR (#5) will
turn on.
4. Press the POWER ON/STANDBY BUTTON (#7) once to turn on the JMC-1250.
The STANDBY LED INDICATOR (#5) will turn off.
Press POWER ON/STANDBY BUTTON (#7) again to turn off the JMC-1250.
The STANDBY LED INDICATOR (#5) will turn on.