128-7052
10 of 16
10
Resistive Circuits, As Well As 4 Wire Polarity Reversal and 5 Wire Alternating 12 Volt
Door Lock Control Circuits
These applications require the use of additional components which may include relays, fixed resistors, or for
convenience, the AS 9159 Door Lock Interface. Refer to the AUDIOVOX Door Lock Wiring Supplement and or the
Audiovox fax back service for information on your particular vehicle for properly connecting to these types of circuits.
2 Pin Blue Connector : Programming Switch
Route the gray and black wires in the 2 pin connector from the previously installed programming switch to the control
module and plug it into the mating blue connector on the side of the module.
4 Pin Antenna/Receiver Connector: (White Connector)
Plug the previously routed three pin connector from the antenna transceiver assemble into the mating connec-
tor of the control module. This connector supplies 12 volts, ground and RF data from the antenna transceiver
to the remote start module. Be certain this connector is firmly seated making good contact to the control unit.
1. RF Programmable Features:
Feature Selection
1 Flash
2 Flash
3 Flash
4 Flash
Default
1 Run Time
5 Min.
10 Min.
15 Min.
20 Min.
10 Min.
2 Ign. 2 During Crank
Off
On
On
3 Light Output During Run
Steady
Flash
Steady
4 Tach Mode
NA
Tach
Tach
5 Voltage Level
NA
NA
NA
6 Trouble Shooting
Off
On
Off
7 Door Locks
1 Sec/1 Sec
3.5 Sec/3.5 Sec
1 Sec/Dbl 1 Sec
1 Sec/1 Sec
8 Crank Time
0.8Sec
1.0 Sec
1.5 Sec
2.0 Sec
1.0
9 Gas/Diesel
Gas
Diesel 10
Diesel 15
Diesel 20 Gas
To program these selectable features:
a.Turn the ignition key to the ON position.
b.Press and release the program switch 3 times.
c. Immediately turn the ignition key OFF, then back to ON.
d.Press and release the program switch 2 times
e. Use the Start button on the transmitter to advance to the feature that you want to change.
EXAMPLE - If you need
to change programmable feature number 3, press and release the start button on the transmitter 3 times in
succession. The parking lights will flash 3 times confirming that selected feature 3 can now be programmed.
f. Use Lock button on the transmitter to change the selection of the programmable feature. If you are not sure what
the setting for any feature is, press the lock button 1 one time, the parking lights will flash once or twice indicating
the features setting.
NOTE:
Once you enter the feature-programming mode, do not allow more that 15 seconds to pass between
steps, or the programming will be terminated.
NOTE:
If the Glow Plug sense wire, Green/Yellow is connected, this wire will have priority over the setting of feature
#9.
2. Programming Tach Rate:
NOTE:
All applications require that tach be programmed.
The unit will not operate unless tach is programmed. If an attempt is made to start the vehicle via the remote start without
first programming tach, the unit will flash the parking lights 7 times indicating tach has not been learned and stored.
If the tach rate is not properly programmed to the specific vehicle, the unit may not realize that the vehicle is running
in certain instances and could re-engage the starter motor.
The Remote Car Starter will learn the tach rate of most vehicles single ignition coils, multiple coil packs, and or single
injector. To learn tach;
a. Turn the ignition key to the ON position.
b. Press and release the program switch 3 times.
