E-6
POWER SOURCE
The JCR-525 operates on 6 X ‘C’ size (UM-2) batteries (not included) or with an external AC-DC adaptor
(not included) with a rating of
DC 9V, 1000mA .
The battery backup for the clock operates on two ‘AAA”
(UM-4) batteries (not included).
A. BATTERY OPERATION
For best performance and longer operating time, we recommend the use of good quality alkaline batteries.
1.
Open the Battery Door by rotating the lock so the mark is pointing to the “OPEN” index mark located
on the cabinet. A “Click” will be heard and you can now remove the door.
2.
Following the polarity (+ and -) diagram shown inside the battery compartment, first insert two ‘AAA’
size (UM-4) battery in the smaller compartment and then the 6 X ‘C’ size (UM-2) batteries.
IMPORTANT:
Be sure that the batteries are installed correctly. Wrong polarity may damage
the unit and void the warranty.
3.
Replace the Battery Door and rotating the lock so the mark is pointing to the “LOCK” index mark
located on the battery door. A “Click” will be heard and the door is now secure.
4. After prolonged use, the battery voltage may discharge to such a low level that the unit will not work
properly. In that case, you need to replace them all at once with fresh good quality batteries.
Remove all exhausted batteries and follow above procedures to replace new batteries.
BATTERY NOTE AND CARE
Danger of explosion if the battery is replaced incorrectly. Replace only with the same type battery.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
If the unit is not to be used for an extended period of time, remove the batteries. An old or leaking
battery can cause damage to the unit and may void the warranty.
Do not try to recharge batteries not intended to be recharged, they can overheat and rupture. (Follow
battery manufacturer’s directions.)
Do not dispose of batteries in fire, batteries may explode or leak.
Only an adult should replace the batteries.
B. AC OPERATION
The JCR-525 will also operate using an AC-DC adaptor (not included). When the AC-DC adaptor is
connected to the DC Jack the batteries are automatically disconnected. Be sure to use an AC-DC
adaptor with a rating of
DC 9V, 1000 mA
and with the following polarity:
If you are using a universal adaptor with an output polarity switch or polarized plugs, be sure to set the
polarity of the center plug to "+".
WARNING:
Never use this radio near water or in the shower when using an AC
Adaptor. Shock or personal injury could occur.
1.5V
UM-2(LR14)"C"SIZE
1.5V
UM-2(LR14)"C"SIZE
1.5V
UM-2(LR14)"C"SIZE
1.5V
UM-2(LR14)"C"SIZE
1.5V
UM-2(LR14)"C"SIZE
1.5V
UM-2(LR14)"C"SIZE
FOR CLOCK
1.5V UM-4"AAA"SIZE
FOR CLOCK
1.5V UM-4"AAA"SIZE
