E-10
SNOOZE FUNCTION
When the alarm sounds, tap the SNOOZE BUTTON (#1) to temporarily turn off the
alarm and activate the snooze function. The alarm will stop and turn on again 9
minutes later. This can be repeated when the alarm sounds again.
Notes:
•
The corresponding AL1 or AL2 alarm indicator will
flash
during the snooze period.
•
To cancel the snooze period and the alarm, press the SOURCE/ STANDBY
BUTTON (#2).
RADIO OPERATION
Listening to the radio:
1. Tap the SOURCE/STANDBY BUTTON (#2) to turn the unit on.
2. If you repeatedly tap the SOURCE/STANDBY BUTTON (#2), you will step through
the different modes available:
FM Radio -> AM Radio -> Bluetooth (bt) - > AUX
3. Tap the SOURCE/STANDBY BUTTON (#2) repeatedly to select either FM or AM
radio mode.
4. The FM or AM frequency will show on the LED display (#11).
5.
Manual Tuning:
Repeatedly
tap the
SKIP BACKWARD
BUTTON (#5) or SKIP
FORWARD
BUTTON (#6) to
manually adjust the frequency.
6.
Automatic Tuning:
Press and hold the SKIP BACKWARD
BUTTON (#5) or
SKIP FORWARD
BUTTON (#6)
to automatically tune to the next or previous
available station.
7. Tap the VOL - / + BUTTONS (#3 / #4) to obtain the desired volume level.
8. Press and hold the SOURCE/STANDBY BUTTON (#2) to turn the radio off.
Notes:
•
Use
Manual Tuning
to select weaker stations that might be skipped during
Automatic Tuning.
•
If the Automatic Tuning does not stop on the exact frequency of the station, for
example, it stops on 88.9 MHz instead of 88.8 MHz, use the manual tuning method
to “fine tune” to the exact frequency of the desired station.
•
When in radio mode, the display will automatically switch back to show the time
after a few seconds.
•
When listening to the radio, you can check the frequency of the station you are
listening by tapping the SKIP BACKWARD
BUTTON (#5) or SKIP FORWARD
BUTTON (#6) once. The unit will automatically return to Standby mode if you
do not tap any button within 10 seconds.
TIPS FOR BEST RADIO RECEPTION
AM - The AM antenna is built inside the radio. If AM reception is weak, change the
position of the unit until the internal antenna picks up the strongest signal.
FM - If FM reception is weak, fully extend the FM ANTENNA (#13) and vary the
position and location of the antenna until you find the strongest signal.
