4
POWER CONNECTION
AC POWER CONNECTION
This product operates on 120V~ 60Hz AC power supply. Plug the AC power cord into a household outlet AC source.
INSTALLING/REPLACING THE BACK-UP BATTERY
This unit is equipped with a battery back-up system, requiring one 3V
CR2032 lithium battery (included) to maintain
the time/calendar settings and radio presets during AC power outage. Prior to first use, please remove the plastic
battery insulator tab to activate the backup battery.
1.
Unscrew and remove the BATTERY COMPARTMENT COVER.
2.
Install one fresh CR2032 lithium battery into the battery compartment following the polarity diagram on the
BATTERY COMPARTMENT COVER. Use only the specified size and type of battery.
3.
Replace the BATTERY COMPARTMENT COVER and tighten its screw.
Note:
The unit will operate without a battery installed but your time & alarm setting and radio presets will be lost and
will have to be reset in the event of power interruption or failure.
IMPORTANT:
Be sure that the battery is installed correctly. Wrong polarity may damage the unit and void the warranty. For best
performance and longer operating time, we recommend the use of good quality alkaline battery.
WARNING
DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD
This product contains a coin/button cell battery. If the coin/button cell battery is swallowed, it
can cause severe internal burns in just 2 hours and can lead to death.
Keep new and used batteries away from children. If the battery compartment does not close
securely, stop using the product and keep it away from children.
If you think batteries might have been swallowed or placed inside any part of the body, seek
immediate medical attention.
BATTERY CARE:
Use only the size and type of battery specified.
If the unit is not to be used for an extended period of time, remove the battery. Old or leaking battery can cause
damage to the unit and may void the warranty.
Do not try to recharge battery not intended to be recharged; they can overheat and rupture (Follow battery
manufacturer’s directions).
Do not dispose of battery in fire, battery may leak or explode.
POWER ON/STANDBY
1.
In standby mode, tap the POWER ON/STANDBY
button once to turn on the unit.
2.
Press and hold
button for about 2 seconds to return the unit to standby mode.
CALENDAR AND TIME SETTING
SETTING THE CALENDAR AND TIME
1.
In standby mode, press and hold the SET MEM button for about 2 seconds to enter the calendar/time set mode.
2.
The year indicator will flash on the LCD DISPLAY for up to 30 seconds prompting for a new entry.
3.
While the display is flashing, repeatedly tap the
or
button to adjust to the correct year. Press and hold the
or
button for faster scanning backward or forward. Tap the SET MEM button to confirm.
4.
Repeat steps #2 to #3 to adjust the month, day, time format, current hour and finally current minute in the same
way.
Notes:
The display sequence in calendar/time set mode will be as follows:
Y
ear → Month → Date → 12/24 Hour Time Format → Real Time Hour → Real Time Min → Normal Time
To check the year while current time is displayed, tap the CALENDAR button once. The LCD DISPLAY will
change to year display for 5 seconds and then revert to current time automatically.
To check the date while current time is displayed, tap the CALENDAR button twice. The LCD DISPLAY will
change to date display for 5 seconds and then revert to current time automatically.
During the time set, if no button is being pressed within 10 seconds, the current display time will be automatically
stored.
Содержание JCR-232
Страница 10: ...9 0314 Printed in China ...
