E-17
CAUTION:
Before charging, please refer to the user manual of the device you wish to charge to make sure
the charging current requested does not exceed 1A (1000mA). Overloading the charging circuit
may damage the unit permanently and void the warranty.
1. The USB charging port of this unit supplies a DC 5V output at 1000 mA maximum current to
charge your smart phone or portable device battery and it cannot support
any other voltage
range.
2. Make sure the device you want to charge has a battery charge rating of DC 5V only.
3. The
USB port of this unit is designed for smart phone or portable device battery charging only
and it cannot support data transfer or connect to computer.
4. Do not connect the USB port of this unit to other external power charger
USB ports, it may
damage both units and void the warranty.
Note:
1.) Some smart phones and portable devices use proprietary USB connections and circuitry, so
they may not charge when plugged into the USB port. Please refer to your device user manual
before you attempt to charge them.
2.) It is normal if the unit gets warm while the USB port is in use and charging your smart phone or
portable device.
3.) Do not charge your smart phone over 12 hours continuously. Disconnect your smart phone or
other portable device from the USB cord once it is fully charged.
RESETTING
If the system does not respond or has erratic operation, you may have experienced an
electrostatic discharge (ESD) or a power surge that triggered the internal computer to shut down
automatically. If this occurs, unplug the AC cord from power source
,
wait for 60 seconds
,
then plug
the AC cord to power source again. The unit will be reset, you need to setup the clock, alarm and
preset radio channels.
CARE AND MAINTENANCE
1. Do not subject the unit to excessive force, shock, dust or extreme temperature.
2. Do not tamper the internal components of the unit.
3. Clean your unit with a dry cloth. Solvent or detergent should never be used.
4. Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
5. Keep your unit away from heating appliances and sources of electrical noise such as
fluorescent lamps or motors.
6. If drop-outs or interruptions occur in the music during CD play, or if
the CD fails to play at all, its bottom surface may require cleaning.
Before playing, wipe the disc from the center outwards with a good
soft cleaning cloth.
CLEANING THE UNIT
•
To prevent fire or shock hazard, disconnect your unit from the AC power source when
cleaning.
•
The finish on the unit may be cleaned with a dust cloth and cared for as other furniture, Use
caution when cleaning and wiping the plastic parts.
•
If the cabinet becomes dusty wipe it with a soft dry dust cloth. Do not use any wax or polish
sprays on the cabinet.
•
If the front panel becomes dirty or smudged with fingerprints it may be cleaned with a soft
cloth slightly dampened with a mild soap and water solution. Never use abrasive cloths or
polishes as these will damage the finish of your unit.
CAUTION:
Never allow any water or other liquids to get inside the unit while cleaning.
Содержание JBS-225
Страница 8: ...E 7 LOCATION OF CONTROLS MAIN UNIT ...