Jensen JBS-225, Руководство пользователя

Страница: 13 / 21

E-12
SNOOZE FUNCTION
Press the
SNOOZE Button
on remote control once to terminate the alarm mode temporarily, and
the alarm will re-start again after 9 minutes on each press. To cancel the SNOOZE mode, press
the
POWER Button
once. The alarm icon “
”
stops flashing.
RADIO OPERATION
1. Tap the
POWER Button
on main unit or remote control to turn on the unit.
2. Tap the
MODE Button
on main unit or remote control to select FM mode, the FM radio
frequency appear in display.
3. To manually tune to a specific radio station, tap the or Button on either main unit or
remote control repeatedly. Use the manual tuning method to tune in weaker stations that are
bypassed during Automatic Tuning.
4. To automatically tune to the next available radio station, press and hold the or
Button
on main unit or remote control for 1-2 seconds until frequency readout on the display begins to
scan and then release the button. The tuner will stop scanning when it receives the next
broadcasting station of adequate signal strength.
5. Press the volume control
/– Button
on main unit or remote control to adjust the
volume control to the desired volume level.
FM & FM-Stereo reception
-
When listening to the FM radio, press the ST./MONO Button on remote control to switch
between stereo mode and mono mode. The FM stereo icon “ST” will appear on the display if
unit is in stereo mode. It is preferable to receive the program in mono when you are receiving a
weak station.
HINTS FOR BEST RECEPTION:
The receiver has a build-in FM wire antenna hanging from the back of the cabinet. This wire
should be totally unwrapped and fully extended for the best reception.
NOTE:
Automatic tuning depends on the signal strength of the broadcasting station, so weak
stations may be skipped. You can manually tune to find the weak stations if a station gets
skipped. With strong signals, the tuner may stop before it reaches the actual broadcast
frequency, so you may need to manually tune for the best reception.
PRESET RADIO STATIONS
1. Press the
POWER Button
on main unit or remote control to turn on the unit.
2. Tap the
MODE Button
on main unit or remote control to select FM radio mode.
3. Tune to the desired radio station either by “manually” or “automatically” tuning method.
4. Tap the
MEM. Button
on remote control, the next available preset memory number flash in
the LED display. (Note:”P01” will blink in the display if you are programming preset for first
time)
5. Tap the PRESET or Button on remote control to select the preset number you want to
assign the station to.
6. Tap the
MEM. Button
on remote control to confirm the setting.
7. Repeat above steps 3 - 6 to preset up to 30 FM stations.
RECALLING PRESET MEMORY CHANNELS
In radio mode, recall the pre-set channels by pressing the
PRESET
or
Button
on remote
control repeatedly.
NOTE:
The clock and FM radio station presets will need to be reset if the power is interrupted or in the
event of a power outage. “12:00” will appear and start blinking on the LCD display to notify you
that the power was interrupted and the clock will need to be reset. Please follow steps 1-7
above to resave the preset stations.