FIG 2.
+
-
Step 4: Cutting the Wall / Ceiling
Using the appropriate wall-cutting tool, blade or Stanley knife, accurately cut the hole in the wall material,
based on the correct cut-out dimension (see FIG 3).
Step 5: Installing
Speaker Leads
For Elite-101 and 202, from your Receiver run one speaker cable thru the wall/ceiling to each Left and Right speaker (see FIG 4).
For
Elite-303,
run
TWO
speaker cables thru the wall/ceiling to each Elite-303 as this model has inbuilt Centre/Left and Centre/Right
speakers as well as Left and Right. (See FIG 5 and FIG 7). In both cases, leave enough slack in wire so that it can hang out of hole.
Step 3: Template:
Use the supplied template and mark the cut-out on the wall or ceiling. To mark, simply trace with a pencil,
along perforated line (see FIG 2). Ensure your markings are level.
Step 2: Fitting Glass Grills
Fit Elite-101 grills squarely and be certain
ALL
4 magnets grab and not just 2 or 3.
For Elite-202/303,
align all 8 pins then gently press
Glass panel into rubber bushes. When removing, pull a little from top, then from bottom to remove evenly.
.
Step 7:
Mounting Speakers
Insert the entire speaker into the hole. Move Speaker wire away
from back of cone to avoid a possible rattle. Using a Phillips head screwdriver, tighten the screws attached to
the dog clamps until you feel Dog Clamps take grip
(9~10 FULL TURNS)
.
At this point you can see the gap
between Speaker Frame and wall/ceiling close fully. Then,
NIP THESE UP - DO NOT OVERTIGHTEN.
See FIG 6.
Note: If you are unable to install these speakers yourself, please contact an authorized electrician or
installation contractor.
Matching Subwoofer : Elite-606:
140 Watts RMS, Heavy-Duty
“monster”
driver with 40oz magnet and 2”Voice Coil is perfectly matched
to ALL
JENSEN
Speakers. Available in stunning Hi-Gloss White or Black. See separate Info Manual.
Step 6:
Red-to-Red & Black to Black
Connect the speaker wire from the positive (RED+) terminal on the receiver to the positive (RED+) terminal on the speaker. Connect
the negative (BLACK-) the same way to the negatives. Note: If you inadvertently reverse one of the connections (i.e. RED to BLACK)
you will notice a severe lack of Bass from your system. This is called wiring your system “Out of Phase”. If this occurs, check the wiring
and reconnect as necessary.
Sound Settings
Boost switch.
Adjust Elite
-
202 / 303 Treble switches to suit your sound preference.
If using a Subwoofer set to (+) to fully maximize performance. Note: Elite-101 has no switches but is
factory preset to Max Boost (+).
Eyeball Tweeters.
You can adjust the angle of the Tweeter slightly in order to compensate for poor
mounting locations. Do this by adjusting Tweeter casing.
DO NOT touch the Tweeter
in any way as
permanent damage may occur.
FIG 3.
Elite-101, 202 & 303
Once final mounting positions are
determined, use pencil and
template (supplied) to mark the
wall and cut-out.
Tem
p
late
Boost switches.
Eyeball Tweeters
Elite
606
Elite-101
Elite-202
Elite-303
JENSEN
