FIG 6.
9~10
full turns
TIPS: 9~10 Full Turns.
With a screw cutting a new
plastic thread, the first few
turns may appear stiff. It will
become easier. The trick is to
gently close the gap between
Speaker panel and wall, then
NIP THESE SCREWS UP – DO
NOT OVERTIGHTEN AND
DO NOT USE A BATTERY DRILL.
TIPS:
1.
Use Laser level or Spirit level to ensure template is perfectly level.
2.
Use a Stud Finder to Pre-plan your locations.
3.
Both ends of Speaker Leads must be Pos (+) to Pos (+) & Neg (-) to Neg (-)
4.
Do not
use Battery Drill.
FIG 5.
.
To amp Centre
To amp L/R
FIG 4.
Elite-101 & 202
Run
1 Speaker lead
to each
Left & Right Speaker.
(FIG 4)
Elite -303
Run
2 Speaker leads
to each
Left & Right Speaker.
(see FIG 7)
Elite-202
