Jenn-Air JWC2450ARB, Руководство по обслуживанию

Страница: 47 / 52

6
The dimensions for a decorative custom door panel are:
23 3
⁄
4
" (60.3 cm) Width
30 5
⁄
16
" (77 cm) Height
3
⁄
4
" (1.9 cm) Thickness (maximum)
1. Turn OFF the refrigerator and disconnect the
power.
2. Remove 1
⁄
8
" top hinge
pin (A). Remove the
door off the bottom
hinge pin, noting
washer location.
3. Remove the door seal
(B) to expose the screw
holes.
Custom Handle
1. A custom handle (not supplied) must be installed.
2. Drill pilot holes through the custom panel to match
the handle. Countersink the holes on the back of
the panel.
3. Attach the custom handle to the front door panel
assembly.
NOTE: The custom handle screws should be installed
through the custom panel and into the custom handle.
The screw heads should be countersunk, so the inside
panel surface can be installed flush with the
refrigerator door.
4. Reinstall the door by
locating it over the
bottom hinge pin and
pushing down and in.
Reinstall the top
hinge pin. Check the
door for proper
alignment. The top
and sides of the door
should run parallel to
the top and side
edges of the cabinet.
Some misalignment is acceptable, but the door
gasket must seal fully against the cabinet.
Realigning the door may be necessary. Using a 1
⁄
8
"
Allen wrench, loosen the two screws on the top
and bottom adjustable door hinge bracket. Adjust
the door to proper alignment. Make sure door
gasket seals fully against the cabinet front.
Retighten screws after making adjustments.
5. Reconnect power to the refrigerator and turn
the control back to the ON setting.
• To avoid electrical shock which can cause severe
personal injury or death, disconnect power to
refrigerator before installing the custom door
panel.
WARNING
A
B
Installing the Custom Door
Panel
(select models)
Hinge
Pin
Top of
Refrigerator
In
Down
Hinge
Bracket
41007710 ENG 5/03 6/11/03 10:58 AM Page 7