Jenn-Air JGC1536BS, Руководство по установке

Страница: 8 / 20

8
3. Install all burner caps and burner bases.
Burner installation:
To install the spreader (B), insert the electrode (C) into the
spreader hole.
Install surface grates:
The surface grates are positioned correctly when the thick ribs
form a frame around the outer edge and the thin ribs are located
across the middle. All burners will be centered with the burner
openings in the grates. See the following illustration.
NOTE: The end grates are different than the center grate. Do not
use the end grate in the center grate position.
4. Plug into a grounded 3 prong outlet.
Complete Installation
Electronic Ignition System
Check Operation of Surface Burners
1. Push in and turn the surface burner control knobs to the “Hi”
position.
The surface burner flame should light within 4 seconds. The
first time a surface burner is lit, it may take longer than
4 seconds to light because of air in the gas line.
2. Check the flame on “Hi” for a blue color. It should be clean
and soft in character. No yellow tip, blowing or lifting of flame
should occur. Occasional orange flashes are normal and
reflect different elements in the air or gas.
3. Repeat for the “Lo” position.
4. Repeat for the “Sim” position.
5. After verifying the proper burner operation, turn the control
knobs to “Off.”
If burners do not light properly:
■
Turn the surface burner control knob to the “Off” position.
■
Check that the power supply cord is plugged in and the
circuit breaker has not tripped or the fuse blown.
■
Check that the gas shutoff valve is set to the “open” position.
■
Check that the burner bases and caps are properly
positioned on the burners.
Recheck the operation of the surface burners. If a burner does
not light at this point, call 1-800-JENN-AIR.
Standard Burner
A. Cap
B. Spreader
C. Electrode
Dual Flame Burner
A. Cap
B. Spreader
C. Electrode
A. Thick ribs
B. Thin ribs C. End grates
D. Center grate
A
B
C
A
B
C
A
A
B
A
C C
A
D
B
A. Correct
B. Incorrect
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
A
B
B