Jenn-Air JBL2088HES, Инструкция по использованию и уходу

Страница: 7 / 104

6
I
NSTALLATION
Door Reinstallation
Materials Needed:
• Phillips screwdriver
•
5
⁄
16
” hex head driver
1. Install hinge assemblies:
• Install top hinge loosely with 5
⁄
16
” hex head
screws.
• Install center hinge with Phillips
screws.
•
Freezer door models:
Install
bottom hinge with 3
⁄
8
” hex head
screws.
2. Freezer door models: Insert
bottom hinge pin.
• Locate bottom hinge hole closest
to outside edge of cabinet, and
insert bottom hinge pin. Replace any door shims,
if present.
3.
Freezer door models:
Place hinge side of freezer
door on bottom hinge pin and hold freezer door
upright while installing center hinge pin with
5
⁄
16
”
hex head driver.
• Replace plastic sleeve.
• Replace any applicable door
shims.
• Make sure the hinge pin is
installed tightly.
4. Place hinge side of refrigerator door on center
hinge pin.
5. While holding refrigerator door upright, tighten
down top hinge with
5
⁄
16
” hex head driver and
replace hinge cover.
Door Reversal
In some installations, reversing the
door swing allows for more convenient
access to stored items. Both doors
can be reversed on freezer
door
models and the fresh food door is
reversible on freezer
drawer models.
Materials Needed:
• Phillips screwdriver
•
5
⁄
16
” hex head driver
• Flat screwdriver
3. Transfer door stops from bottom edge of fresh food
door and freezer door, if applicable, to opposite
side of door edge.
• Use a Phillips screwdriver
for removal and installation.
4. Install handles (see below).
5. Reinstall the door(s).
To avoid possible injury and damage to
property:
• Place doors on a nonabrasive surface protected by
towels or rugs while working directly on doors.
CAUTION
Handles
Handle Removal
(style varies by model)
Materials Needed:
• 3
⁄
32
” Allen wrench
To Remove:
• Remove set screw from
handle mounting post
using
3
⁄
32
” Allen wrench.
• Repeat the procedure on
all posts to remove the
handle.
To Replace:
• Align handle with the mounting posts.
• Fully tighten all set screws to secure handle
in place.
1. Remove door(s) (see page 4).
2. Transfer cabinet plugs and cabinet screws to
opposite side of cabinet.
• Remove cabinet plugs with flat blade of
screwdriver tip wrapped in masking tape.
• Remove center mullion screws with 5
⁄
16
” hex head
screwdriver.
• Freezer door models: Remove bottom mullion
screws with
3
⁄
8
” hex head driver.