15
3.
Remove the locking plate as shown.
4.
Using a 1/2" open end wrench, turn the bushing located
underneath the bottom of the hinge.
■
Turn the bushing to the left to lower the door.
■
Turn the bushing to the right to raise the door.
5.
After adjusting, check the doors to make sure they are even
across the top and bottom. If the doors are not even, continue
to turn the bushing to adjust the door height.
6.
Replace the locking plate.
7.
Turn the bushing slightly to align the hinge and locking plate
screw holes.
8.
Replace the door stop screw or screws and tighten.
9.
Recheck to make sure the doors are aligned and even.
Door Swing Adjustment
1.
Check that the refrigerator door can open freely. If the door
opens too wide, remove the door stop screw or screws
(depending on your model) from the bottom hinge. See “Door
Height Adjustment” earlier in this section.
2.
Hold the door open to a position that is less than 90°.
3.
Replace the door stop screw or screws in the bottom hinge
and tighten.
Door-to-Door or Door-to-Refrigerator Trim Adjustment
1.
Loosen, but do not remove, the four Torx
†
27 flat-head
mounting screws. Remove and discard the two 1/4" hex-head
mounting screws.
2.
Adjust the top hinge of either door to align it with the other
door or the refrigerator trim.
†
TORX is a trademark of Acument Intellectual Properties, LLC
3.
Tighten the four Torx† 27 flat-head mounting screws to a
torque of approximately 100 inch-pounds (11.3 Nm).
Install Side Panel
If the built-in area depth is 25" (63.5 cm) or more, the side panels
can be installed inside the side trim or attached to the outside of
the side trim.
IMPORTANT:
JennAir is not responsible for the removal or
addition of molding or decorative panels that would not allow
access to the refrigerator for service.
1.
For the inside side trim piece, slide the front edge of the routed
side panel into the trim piece.
2.
Nail the rear edge of the panel to the support board.
Install Base Grille
There are two pieces to the base grille to allow for a custom fit: the
base grille itself and the skirt. The skirt can be added to the base
grille in order to extend it all the way to the floor.
1.
To see whether the skirt is needed, place the base grille into
position. Do not attach the base grille to the refrigerator.
Measure the distance between the bottom of the base grille
and the floor. The gap must be a minimum of 1/2" (1.27 cm) in
order to add the skirt.
NOTE:
If the gap measures less than 1/2" (1.27 cm), skip steps
3 and 4 of the instructions, and install the base grille only.
2.
Remove the film from the base grille.
A
B
C
A. 130°
B. 110°
C. 90°
A
B
A. Torx 27 flat-head mounting screws
B. 1/4" hex-head mounting screws
A
B
A. Support board (mounted to back wall)
B. Cab side trim
