11
4. Open both drawers less than midway. Place the level on the
side flange beside the drawers as shown. Turn the front
leveling bolts together in order to either raise or lower the
appliance until the sides of the refrigerator drawers are
plumb.
5. Remove the level and close the drawers. Recheck the gap
between the top of the drawer and the countertop. If the gap
measures less than
³⁄₈
" (9.5 mm), turn all four leveling bolts
equally to raise the leveling legs (this will lower the appliance).
Recheck the level.
NOTE: Be sure to recheck the horizontal level of the top
drawer.
6. Be sure all four levelers are on the floor and supporting the
full weight of the refrigerator drawers.
Attach the Mounting Brackets to
Adjacent Cabinets
IMPORTANT: To avoid damage to your cabinets or countertop,
be sure to secure the mounting brackets to the adjacent
cabinets.
1. Center the refrigerator drawers cabinet in the opening.
2. Pull out the upper drawer far enough to reach the mounting
brackets.
NOTE: Do not pull the drawer out more than midway.
3. Using the upper mounting brackets as a guide, predrill two
¹⁄₈
" (3.18 mm) holes through the mounting brackets (for each
side) into the adjacent cabinets. Be sure to drill at least two
holes per mounting bracket.
NOTE: Be sure the refrigerator drawers are level before
securing the upper mounting brackets.
4. Using four #8 x
¹⁄₂
" pan-head screws, attach the upper
mounting brackets to the adjacent cabinets.
5. Repeat the process for the lower drawer.
Reinstall the Base Grille
1. Be sure the Power On/Off Switch is on.
2. Reinstall the base grille.
NOTE: The bottom of the base grille has a notch and a wider
flange than the top.
3. Using a Phillips screwdriver, drive the four screws into the
base grille as shown. Tighten all screws.
Complete Installation
1. Remove all boxes, parts packages and packing materials
from the interior of the refrigerator drawers.
2. Remove the protective film.
3. Clean the refrigerator drawers before use. See “Cleaning”
section in the Use & Care Guide for instructions.
4. The controls are preset at the factory to the default setting
38°F (3°C) for the upper and lower drawers. Be sure that the
compressor is operating properly and that all the lights are
working.
5. Reinstall the wire baskets in the refrigerator drawers. You can
install both wire baskets in the upper drawer, or, install one
wire basket in the upper drawer and the other wire basket in
the lower drawer.
6. If construction will continue after the refrigerator drawers
have been installed, turn the power Off for both Drawers. See
“Using the Controls” in the Use & Care Guide for instructions.
To get the most efficient use from your new refrigerator drawers,
read your Use & Care Guide. Keep these Installation Instructions
and Use & Care Guide near the refrigerator drawers for easy
reference.
A. Check the level from front to back.
A. Mounting brackets
A
A
A. Power On/Off Switch (ON)
A. Bottom flange
A. Screws
A
A
A
A
Содержание DOUBLE REFRIGERATOR DRAWERS
Страница 12: ...12 Notes...
