於完成安裝熱水器後，
必須關閉電源
，開啟水龍頭並轉至紅點位置，讓冷水及氣泡流出至少一
分鐘，然後可關閉水龍頭。
此步驟只需在第一次安裝後、每一次維修後或暫停供水後進行，以避免因水箱沒水或合適的水
量而導致發熱管損壞。
After the installation of the water heater,
make sure the power supply is switched off
and turn on the
Non Pressure Type Water Mixer. Keep the hot water on until the tank is completely full and water
running out for at least 1 minute before turning off.
This procedure is only required after the first installation, maintenance or water shortage, to prevent
the damage of the heating element when the inner tank is empty or without suitable water level.
3.產品安裝指引
Instructions for Installation
3.1
牆壁掛架安裝指引
Installing the Bracket
3.1.1
請選擇一幅能承受熱水器重量的牆壁或混
凝土牆，記下正確的位置，並用合適螺絲
固定裝上牆壁掛架。
Choose a concrete wall that is strong enough to bear
the weight of the heater. Mark the position for fixing
the mounting bracket and secure it with suitable
Screw.
3.1.2
請確保所有接合點連接正確，並無滲漏。
Make sure all the parts are well connected without any
leakage.
3.1.3
請根據圖示把熱水器垂直安裝；傾斜度不
能大於5度。
Install the water heater vertically as shown; the
gradient CANNOT be greater than 5 degrees.
