13
JREMO 10K
Industrial radio remote controller
CHAPTER 3. INSTALLATION & FUNCTION SETTING
3-3-2. INSTALLATION SEQUENCE
A. Power off equipment(ex. crane).
B. To install receiver always try to use with the Rx Fixing Plate or Rx Fixing
Bracket when applicable.
C. Connect each wire end of receiver cable to a mating connector of equip-
ment(ex. crane).
1. Confirm both circuit diagram of receiver and equipment(ex. crane) are
in sequence and connected correctly.
2. Confirm ground is o.k.
3. Check and confirm power source.
4. Make sure the selector switch positioned to pendent.
D. Power on transmitter :
1. Turn on the rotary s/w after released up the EMS button.
2. Press Start Pushbutton of the transmitter and,
3. Confirm if the receiver MAIN Lamp is on.
E. Press each function button of transmitter and confirm remote opera-
tion in a good working condition by confirming led lights inside the relay
board of receiver.
F. Close upper case of receiver and set the selector switch to remote posi-
tion.
3-4 HOW TO START & USE PASSWORD(PWD)
For the safety and secure operation
JREMO
series has adopted several
types of start functions as following to achieve enhanced safety :
■ Main ON Function
Std : EMS UP ⇨ Rotary S/W ON ⇨ (PWD) ⇨ Any button, Main ON
Opt. : EMS UP ⇨ Rotary S/W ON ⇨ (PWD) ⇨ Start P/B, Main ON
■ PWD setting
An optional setting method may be used by referring to a separate
PWD setting manual which is not included for a standard provision.
