5 |
P a g e
Keep handles dry, clean, and free from oil and grease.
14.
DISCONNECT TOOLS:
When not in use, before servicing and when changing accessories,
such as blades, bits and cutters.
15.
REMOVE ADJUSTING KEYS AND WRENCHES:
Form habit of checking to see that keys and
adjusting wrenches are removed from tool before turning it on.
16.
AVOID UNINTENTIONAL STARTING:
Don’t carry plugged in hand tool with finger on switch.
Be sure switch is off when plugging in.
17.
OUTDOOR USE EXTENSION CORDS:
When tool is used outdoors, use only extension cords
intended for outdoors and so marked.
18.
STAY ALERT:
Watch what you are doing, use common sense. Do not operate tool when you
are tired.
19.
CHECK DAMAGED PARTS:
Before further use of tool, a guard or other part that is damaged
should be carefully checked to determine that it will operate properly and perform its
intended function. Check for alignment of moving parts, binding of moving parts, breaking
of parts, mounting and any other conditions that may affect its operation. A guard or other
part that is damaged should be properly repaired or replaced by an authorised service
centre unless otherwise indicated elsewhere in this instruction manual.
Have defective switches replaced by authorised service centre.
Do not use tool if switch does not turn it on and off.
20.
AVOID USING A POWERTOOL FOR APPLICATIONS OTHER THAN THOSE SPECIFED.
Never use a power tool for applications other than those specified in the instruction manual.
21.
ENSURE SAFE OPERATION THROUGH CORRECT HANDLING.
Secure safe operation through
correct handling by observing the instruction herein.
Do not employ accessories other than those specified herein; otherwise a hazardous condition
may be created.
Never allow a power tool to be used by persons not familiar with correct handling (such as
children) or those who cannot handle the tool correctly.
22.
CONFIRM THAT NO ITEMS SUCH AS AN ELECTRIC CABLE OR CONDUIT ARE BURIED INSIDE:
In places where live wiring may be hidden behind a wall, floor, ceiling, etc. Do not hold or
contact any metal parts of the tool. In such cases metal parts could become electrically live
and present a serious shock hazard.
23.
KEEP THE RIGHT PARTS IN THE RIGHT POSITIONS:
Do not remove covers and screws which
have been factory mounted. They perform important retrospective roles. Keep them in the
right positions.
24.
SHOULD THE PLASTIC HOUSING OR HANDLE OF A POWER TOOL BE CRACKED OR
DEFORMED. DO NOT USE IT:
Since cracked or deformed parts may lead to an operator
receiving an electric shock, do not use such a power tool. Immediately have it repaired.
25.
SECURELY MOUNT ACCESSORIES AND BLADES TO THE TOOL MAIN BODY:
Extra care must
be taken when using tools on elevated locations (such as a roof, ladder, scaffold or such like)
to prevent injury to someone on a lower level in the event of the tool and or accessory
should drop.
