ABM-28
ABM-28
Operator’s Manual
11
3.2. Setting bevel parameters
Loosen the lever
1
(Figure 5) and rotate the lever
2
to set a proper milling head
penetration in working material on the pitch
3
(one graduation equals 1 mm
, 0.04’’),
and afterward lock the position using the lever
1
.
Figure 5.
View of milling unit
Then, loosen the levers
4
and
5
, and rotate the milling unit in a way to set
a proper bevel angle on the pitch
6
, and afterward lock the levers
4
and
5
.
It is recommended to start bevelling with the milling head maximally retracted,
especially when milling at the angle of 0°.
If the milling unit is inclined at a high negative angle, hold its handles tightly
during readjusting of the milling head penetration near the position where the milling
head is maximally retracted, to not allow the milling unit to slip down from the support
when the bevel depth lock lever
1
is unlocked.
1
3
2
6
5
4