ABM-28
ABM-28
Operator’s Manual
10
If the plate is to be machined at the negative angle (from the bottom), loosen two
milling unit support screws using 4 mm hex wrench, and set the indicator to the value
of the plate thickness (
8
). Position the milling unit support on the screws (
9
), place
the washers under the nuts (
10
) in order shown in Figure 3, and tighten the nuts
using 13 mm flat wrench.
Set the lever
1
in the position from Figure 4, insert the milling unit into the
support (
2
), and lock the bevel depth lock lever (
3
). If the plate is to be machined at
the positive angle (from the top), catch the chips container on the brackets (
4
).
Figure 4.
Method of mounting milling unit
2
3
4
1