Jegs 86004, Руководство пользователя

Страница: 12 / 21

Operation Cont.
11
Receptacles and Extension Cords
Only use high quality, well-insulated, extension cords
in good condition with generator receptacles.
This generator is equipped
with the following receptacles:
• Two 120 Volt AC, 20 Amp receptacles.
• One 120 Volt AC,30 Amp RV receptacle
• 120 / 240 Volt AC, 30 Amp twist lock receptacle
• (NEMA L14-30).
Do not connect 3-phase loads to the
generator.
• Do not move the voltage selector switch with
devices connected. Disconnect all electrical loads
before moving the switch. Failure to do so could
damage the switch or generator.
• 12 Volt 8.3 Amp Output is for batteries only!
How to Stop the Engine
• All loads must be disconnected from the
generator. Never start or stop the engine with any
electrical devices plugged in to the receptacles
(Fig. 10).
• Turn the fuel valve to the “OFF” position (Fig. 11)
• Turn the engine ON/OFF switch to the “OFF”
position (Fig. 12).
Figure 10
Figure 12
Figure 11
• 12 Volt 8.3 Amp Output
• (For charging batteries only)
120 Volt AC, 20 Amp receptacle
• This receptacle has a 20 Amp push-to reset
circuit breaker to protect against overload.
• Each socket is rated to operate 120 Volt, AC,
single phase, 60Hz loads requiring up to 2400
watts (2.4 kW) at 20 Amps.
• Use extension cords having a minimum rating
of 125 Volts AC, 20 Amps.
120 / 240 Volt AC, 30 Amp locking receptacle
• This receptacle has a 30 Amp push-to-reset
circuit breaker to protect against overload.
• This receptacle is rated to operate 120 Volt, AC,
single phase, 60Hz loads requiring up to 3600
watts (3.6 kW) at 30 Amps. It is also rated to
operate 240 Volt AC, single phase, 60Hz loads.
• Use a NEMA L14-30 plug with this receptacle.
Voltage selector switch
This switch toggles between 120 volts and 240 volts,
AC output; on the respective receptacles.