Jegs 86004, Руководство пользователя

Страница: 11 / 21

Generator must be properly grounded to
prevent electrocution.
Pull cord recoils rapidly and pulls arm
towards engine faster than you can let
go which could result in injury.
• Only operate generator on a level surface.
• Always connect the nut and ground terminal on
the frame to an appropriate ground source.
• To avoid recoil, pull starter cord slowly until
resistance is felt, then pull rapidly.
10
Operation
This generator produces a very high
voltage which could result in burn or
electrocution causing serious injury or death.
• Never handle the generator, electronic devices, or
any cord while standing in water, while barefoot,
or when hands or feet are wet.
• Always keep the generator dry. Never operate
generator in rain or under wet conditions.
• Use a ground fault circuit interrupter (GFCI) in a
damp or highly conductive area, such as metal
decking or steel work.
• Never plug electronic devices into generator
having frayed, worn, or bare wires. Never touch
bare wires or make contact with receptacles.
• Never permit a child or unqualified person to
operate the generator. Keep children a minimum
of 10 feet away from the generator at all times.
• If using the generator for back up power, notify
the utility company.
• Install a transfer switch. Failure to isolate the
generator from the power utility could result in
serious injury or death to electric utility workers.
How to Start the Engine
• Place the generator on a level surface. All electrical
loads must be disconnected from generator.
• Turn fuel valve to the “ON” position. (See fig. 6)
• Slide the choke lever to the “Choke” position.
(See fig. 7)
• Skip this step if the engine is hot.
• For manual start, turn the engine ON/OFF switch
to the “ON” position. Pull the recoil handle (starter
cord) slowly until resistance is felt, then pull
rapidly. (See fig. 8)
• Let engine run for several seconds and then
gradually, as engine warms up, slide the choke
lever towards the “RUN” position until the choke
is fully slid to the “RUN” position. (See fig. 9)
Connecting your Generator
to an Electrical System
If connecting the generator to a building’s electrical
system for standby power, you must use a qualified
electrician to install a transfer switch. The power from
the generator must be isolated from the circuit breaker
or alternative power source. The connection must
comply with all electrical codes and applicable laws.
Figure 6
Figure 8
Figure 7
Figure 9