General Operating Instructions
TO PREVENT SERIOUS INJURY:
Wear ANSI-approved safety goggles and heavy-duty work gloves during use.
1.
BEFORE EACH USE, lubricate the Shears:
a.
Make sure that the Power Switch is in the OFF position, then plug in the Shears.
b.
Turn on the Shears and run for one minute.
c.
Turn off the Shears, then unplug from outlet.
d.
Put 3-4 drops of light machine oil in the Oil Port.
e.
Turn the tool on its side, and put 1-2 drops of light machine oil above the Upper Blade.
2. Make a few practice cuts on scrap material before cutting your workpiece.
3. Make sure that the Power Switch is in the OFF position, and then plug in the Shears.
4. Turn on the Shears.
Note:
To prevent damage to the blades,
do not cut across a welded seam.
5. To cut material, fit the Guide over the edge of the material, and move the tool slowly forward along the
desired cut line.
6. To prevent accidents, turn off the tool and unplug it after use. Clean, and then store the tool indoors out of
children’s reach.
Oil Port
Area above
Upper Blade
Figure D
10
1-800-345-4545 jegs.com
Содержание 81374
Страница 15: ...Assembly Diagram 15 1 800 345 4545 jegs com ...
