Programming method
Anything you set here will be remembered even if you disconnect the battery.
Programming procedure:
1.
Put the gun into SEMI and power up the gun. You will feel one short vibration.
2.
Pull the trigger once (before the second longer vibration).
3.
The gun will make 3 quick vibrations. You are now in programming mode and the
device is waiting for option you want to change. If you do nothing for 2 seconds,
it will go to step
4.
a)
Pull the trigger “X” times where X is the number of the option you want to
change.
(
1. MODE, 2. BURST TIME - Reduction, 3. BURST TIME - Increase, ...
)
b)
The gun will vibrate “X” times to confirm the option number selected.
c)
To change attribute pull the trigger “X” times where X is the number of
the attribute you want to change. The gun will vibrate with each trigger
pull to signal detection trigger pull.
d)
After a short pause, the gun give 3 quick vibrations to signal that
processor unit accepted new settings and is ready for new input.
e)
Go to step
3. a)
to select another option or do nothing.
4.
The gun will make a long vibration signaling that programming is done and the
gun is ready to fire.
5.
At last put the gun into SEMI and fire the gun
5 times
to teach device right burst
timing. You should do this every time you power up the gun – fire the first 5 shots in
SEMI. Ignore this step for a gun with no SEMI capability such as M249.
4
