Detailed programming scheme
MODE
- 1.attribute: same as normal AEG (without Processor unit)
2.attribute: in AUTO mode firstly shoot burst, after pause goes to full-auto
if the trigger is held down. Delay is programmable
(
6.choice)
3.attribute: with selector on AUTO the gun fires only semi.
4.attribute: with selector on AUTO the gun fires only burst (default 3 shots)
5.attribute: with selector on AUTO the gun fires only semi with forced time
delays between shots. Delay is programmable
(
6.choice)
BURST TIME
- Each trigger pull will shorten/lengthen the burst time about 12%
MOTOR SPEED
- Each trigger pull will slow down/speed up the motor about 5%.
Good for too high rate of fire gun. (Factory default is 100%)
ACTIVE BRAKING
- you can disable motor active braking, which uses the excess
energy from the motor to stop it. In semi fire mode piston isn‘t partially
stretched, spring is fully released, parts in mechabox aren‘t under strain and
nozzle locks hop-up chamber in greater part. (factory default is ON)
DELAY -
You can change delay between Burst and Full-auto in MODE = 2
(Save - Semi
- Burst/Full)
and delay between Semi shots in MODE = 5
(Save - Semi - Semi)
.
Default delay is normal, you can choose shorter or longer time delay for
both fire modes.
SMART ROF -
It works only with MOTOR SPEED – reduction
(
4.choice).
It reduce rate
of fire (RoF) in full-auto without losing first shot trigger response, where the
RoF is dropped down smoothly for the rest of the fullauto burst.
BATTERY CUT OFF
- Use this feature only for Lixx batteries with the right number of cells
as it is set in program. When Processor unit detects low voltage battery, the
motor will vibrate after each shot. When the battery is dead the gun will
vibrate instead of firing.
FACTORY RESET
-
Immediately pull and hold the trigger until long vibration. The gun
will no longer respond from now. Disconnect and connect battery - now is Pro-
cessor unit back in factory settings.
2
