Jefferson JEFWASPET065HP/A, Руководство пользователя

Страница: 8 / 36

8
USER MANUAL v2.1
JEFWASPET065HP-A
6.5HP Petrol Pressure Washer
www.jeffersontools.com
CONNECTIONS
Connecting the pressure hose to the pump
1. Pull back the high pressure outlet fitting collar. Insert the connector into the quick release fitting
and release the collar to close the fitting. Carefully tug on the fitting to ensure it is secured.
Connecting the hose to the spray gun
1. Pull back the slip ring on the female quick connect fitting and connect with the male outlet on
the spray gun.
2. Release the slip ring on the female quick disconnect and twist. Listen for a "click" to ensure that
the coupling is secure.
Connecting the Lance to the Spray Gun
1. Remove the protective plastic cap on the lance connection.
2. Thread the lance connection onto the spray gun as shown
3. Tighten the nut to secure
Connecting the Nozzle / Removing the Nozzle
1. Insert the nozzle into the quick- connect fitting on the lance and press to snap in the nozzle.
2. To remove pull back the slip ring to eject the nozzle. See page 8 for more information about
nozzle selection for various applications.
Connecting the pressure pump to the water supply
1.
Connect the garden hose to the water supply and turn the water supply on to run water through
the hose and remove any debris prior to connecting to the pressure washer, then turn off the
supply.
2. Check the filter inside the pressure washer inlet is clean and undamaged. Thread the garden
hose fitting into the water hose inlet. Hand tighten to make a secure connection.
3. Turn on the water supply and check that there are no leaks. Ensure that there is a minimum of
20psi and a flow rate of 5GPM .
Preparing the pump for first use
This equipment is shipped with a special oil plug to prevent oil leakage from the pump during
shipping.
You will need to replace the shipping plug with the breather plug provided before use. Hand tighten
the breather plug to avoid damaging the threads.