Jefferson JEFWASPET065HP/A, Руководство пользователя

Страница: 12 / 36

12
USER MANUAL v2.1
JEFWASPET065HP-A
6.5HP Petrol Pressure Washer
www.jeffersontools.com
CLEANING WITH DETERGENTS
WARNING:
Use only soaps and chemicals designed for petrol washers - if in doubt contact your nearest Jefferson Tools retailer
for advise. Do not use bleach to spray with this equipment. Applying chemicals or cleaning solvents is a low pressure
operation. Chemicals, soaps and cleaning solvents will not siphon when a high pressure nozzle is used. Always use the
black detergent nozzle for chemical and solvent cleaning.
To Apply Detergent:
1.
With pressure washer turned off, Prepare the detergent solution as recommended by the manufacturer.
2. Remove the detergent tank cap (located in front of the pressure washer).
3. Fill the tank with the prepared detergent solution using a funnel if necessary. Replace the detergent tank cap.
4. Lock the trigger and attach the Black Detergent Nozzle to the wand.
5. Start the pressure washer. Unlock the trigger and squeeze the spray gun trigger and apply detergent to the cleaning surface using long, even &
overlapping strokes.
6. Allow the detergent to "soak in" for 3-5 minutes before washing and rinsing. Reapply as required to prevent the surface from drying. Do not
allow the detergent to dry on the surface (this will result in streaking).
To Rinse:
1. Shut down the pressure washer. Replace the detergent nozzle with a suitable cleaning nozzle. Squeeze the trigger and wait for the detergent to
clear.
2. Keep the spray gun a safe distance from the area you plan to spray.
3. Start at the top of the cleaning area working down with consistent overlapping strokes.
Flush the system:
1. Turn off the engine and fill the detergent tank with clean water.
2.
Remove the nozzle and turn the washer back on.
3. Point the wand in a safe direction and squeeze the trigger to flush clean
water through the detergent tank and pressure washer system until it is
thoroughly clean.
SHUTDOWN PROCEDURE
1 . If you have used any chemicals rinse system thoroughly as outlined previously to prevent damage to the pump.
Never turn the water supply off when the engine is running.
2.
To stop the engine set the engine switch on the side of the engine to the
OFF
position.
3. Turn the water supply off and disconnect the garden hose from the pressure washer.
4. Pull the trigger on the spray gun to relieve any water pressure in the hose or the gun.
5. Allow the engine to cool before folding down the frame in preparation for storage.
WARNING:
Leaving chemicals and cleaning solutions in
the pressure pump could result in damage
to the pump components. Any damage
caused by soap or detergent residue will not
be covered under warranty.