Jefferson JEFWASPET065HP/A, Руководство пользователя

Страница: 10 / 36

10
USER MANUAL v2.1
JEFWASPET065HP-A
6.5HP Petrol Pressure Washer
www.jeffersontools.com
STARTING THE PRESSURE WASHER
1. Ensure that the equipment is operating in a well ventilated
outdoor area. Check fuel level and top-up if necessary.
2. Check the engine oil level. On first use there will be a small
amount of oil left from factory testing but this will always require
topping up.
This equipment is shipped with a low-oil sensor that will prevent
startup if insufficient oil is available for operation. The low oil
sensor will also shut down the engine when level is too low to
protect the engine.
3.
Check that the filter is clean and in place at the water inlet (cone
side facing out).
4. Connect the water supply to the pump inlet. ( Note: the water
source must provide a minimum of 19L / Min at 20PSI for this
equipment to operate.
5.
Connect the high pressure water hose to the pump outlet. Turn on the
water supply.
6.
Make sure that the Throttle lever is set to the "
FAST
" position. Slide the
fuel lever to the " ON " position and allow the fuel to flow to the engine.
Slide the choke lever to the "Start" position. Turn the Engine ON/OFF switch to the ON position. Pull the starter cord to start the engine. Slide the
choke lever to RUN position.
7. Stand on a stable surface, gripping the gun with both hands, and press the trigger to begin spraying - e xpect the gun to kickback when
triggered
. Adjust the spray nozzle as required for the task.
8. Release the trigger to stop water flow and enter bypass mode pior to spraying.
WARNING:
•
Do not leave the pressure washer in bypass mode for more than 2 minutes at a time. Water temperature inside the
pressure washer pump will rise to dangerous level and can result in damage to internal components within the pump.
•
Failure to follow this warning can result in personal injury and damage to the equipment and will void the warranty.
•
Do not run the pump without a connection to the water supply. Any damage caused by such use will void the
warranty.
•
Always wear the appropriate safety equipment when using this equipment.
•
The high pressure water jet produced can cut through skin and underlying tissues resulting in serious injury.
•
Never point the jet at people or animals.
•
Beware of kickback when spray gun trigger is pressed.