Jefferson JEFSWCFF14-110A, Руководство пользователя

Страница: 8 / 16

USER MANUAL
v.1.1
JEFSWCFF14-110A / JEFSWCFF14-230A
14" / 355mm
CUT OFF SAW
www.jeffersontools.com
8
OPERATION
Important: This equipment should only be used by competent operators who have
familiarised themselves with the safety and operating instructions contained in this manual.
Always wear appropriate Personal Protection Equipment including suitably rated eye,
hearing and respiratory protection for the materials you are cutting.
1. Check the equipment, blade, guards and cable/plug connection for damage or defects
prior to use. Do not use the saw if any problems are detected.
2.
Ensure the saw is set-up as required, set the vice and fence angle as required.
3. Ensure that the workpiece is fully secured between the vice and the fence before
attempting to make any cuts with the saw.
4. Connect the saw to the power supply ensuring the rating matches the specifications of
the saw.
5.
Push the lock-off button and pull the trigger to engage the motor and cutting blade.
6. Carefully bring the disc down onto the workpiece and allow it to cut its way smoothly
through the material. Do not use excessive force.
6. Once the cut is complete, raise the arm to remove the cutting blade from the workpiece
before releasing the trigger to stop the motor. The cutting blade will continue to rotate for a
few seconds after the trigger is released. Ensure that you keep your hands etc. away from
the blade until it fully stops.
Adjusting the Cutting Angle:
The cutting angle can be adjusted using the hex key supplied to loosen the
two hex bolts and rotate the fence through 90° / 45
°
as shown below. Use
the guide to set the angle accurately and tighten the hex bolts to secure
the fence before cutting (See
Fig.1 ).
Adjusting the Fence Position:
The standard distance between the vice and the fence is 175mm. You
can adjust this position by removing the two hex bolts using the hex
key provided. Move the fence as required to one of the other two fixing
positions before tightening the hex bolts to secure the fence in position for
cutting. (See
Fig.2 ).
Replacing a Cutting Blade
Important: Before attempting to remove a cutting blade always ensure
that the saw is switched off and disconnected from the power supply to
eliminate the risk of accidental starting during this operation.
1.
Loosen and remove the two screws securing the Lower Guard /
Spark Shield (See Fig.3 ).
2. While holding the Spindle Lock lever, remove the disc bolt using
the hex key and turning in an anti-clockwise direction (See Fig.4 &
Fig.5
).
3. Clean any debris or materials from the inner flange (checking
and ensuring it is in good working order).
4.
Replace the blade by placing it on the mounting plate and
ensure thatit turns smoothly freely and on a level plane (without
wobbling) before reinserting the disc bolt and securley tightening in
a clockwise direction.
5.
Replace the Lower Guard / Spark Shield by locating the center
pivioting section into the raised center section of the Upper Guard
and carefully re-securing the screws. (See
Fig.6 ).
Fig 1: Adjusting the cutting angle
Fig 2: Adjusting the fence position
Fig 3: Remove the lower guard
Fig 4: Holding the Spindle Lock
Fig 5: Removing the disc bolt Fig 6: Replacing the Lower Guard