Jefferson JEFPLAS40A-DV, Руководство пользователя

Страница: 10 / 20

10
USER MANUAL
v1.1
40A Plasma Cutter - Dual Voltage ~ 50Hz
JEFPLAS40A-DV
www.jeffersontools.com
MAINTENANCE
Ensure all repair and replacement of parts is carried out by a qualified technician using only Jefferson approved
replacement parts. A list spare parts and a parts diagram are supplied later in this document. Contact your nearest
Jefferson dealer for any information or advice required.
WARNING: To prevent serious injury from accidental operation:
Turn the Power Switch of the Plasma Cutter to its “OFF” / "O" position and unplug the plasma cutter from its
electrical outlet before performing any inspection, maintenance, or cleaning procedures.
CLEANING, MAINTENANCE, AND LUBRICATION PROCEDURE
1. Before each use, inspect the general condition of the plasma cutter. Check for loose screws, cracked or broken
parts, damaged electrical wiring, and any other condition that may affect its safe operation.
2. Maintain the air supply according to the component manufacturers' instructions.
3. Drain the dryer regularly. Performing routine air supply maintenance will allow the tool to operate more safely and
will also reduce wear on the tool.
4. After Use, clean external surfaces of the plasma cutter with clean cloth.
5. Periodically, using compressed air, blow out all dust and debris from the interior.
6. If the unit repeatedly shuts down from thermal overload, stop all use. Have the Plasma Cutter inspected and
repaired by a qualified service technician.
7. Store the plasma cutter and accessories in a clean and dry location out of reach of children.