Jefferson JEFBLTSND075-230, Руководство пользователя

Страница: 6 / 20

6
USER MANUAL
v1.1
JEFBLTSND075-230
•
JEFBLTSND150-230
•
JEFBLTSND150-400
BELT LINISHER
www.jeffersontools.com
ELECTRICAL SAFETY
Ensure that you check the equipment thoroughly to ensure it is safe and fit for purpose before each
use. It is important that you inspect all plugs, sockets, power cables and electrical fittings for wear
and damage and repair or replace any defective components. The risk of electric shock can be
minimised by the correct use of the appropriate electrical safety devices.
•
We recommend that you fit a Residual Current Circuit Breaker (RCCB) in the main distribution board and that a
Residual Current Device (RCD) is used when operating this equipment.
•
The Electricity at Work Act 1989 includes legislation that places legal implications on employers to ensure
the safety of electrical devices in the workplace. The regulations dictate that all portable equipment must be
inspected regularly and tested to ensure that it is safe for use. 'Portable equipment' means any electrical item
that can be moved and this is often referred to as Portable Appliance Testing (PAT). PAT testing should be carried
out regularly on this equipment by trained, authorised personnel, as required by the legislation.
•
The Health and Safety at Work Act 1974 states that it is the responsibility of the owner of electrical appliances to
ensure that both the equipment and working environments are maintained to ensure safe operation at all times.
•
Check that all equipment cables are secure, correctly insulated, free from damage, and protected against short
circuit and overload before connecting to the power supply. Do not use worn or damaged cables, plugs, sockets
or other fittings.
•
Ensure that the power supply matches voltage requirements specified on the equipment and that the plug is
wired correctly and fitted with the correct fuse.
•
If the electrical fuse blows, ensure it is replaced by an identical type of fuse with the same rating.
•
Never pull or manoeuvre this equipment into position using the power cable.
•
Ensure the power cable is kept away from heat, oil and sharp edges.
•
We recommend that the equipment is connected directly to the power supply without the use of extension leads
as the resulting voltage drop can reduce motor performance.
•
Always disconnect the equipment from the power source before servicing, inspecting, maintaining, cleaning,
replacing or checking any parts.
WORK AREA SAFETY
•
Always ensure a sufficient working area, that is clean and tidy, and free access to the machine and peripheral
devices.
•
Ensure sufficient lighting is available in the working area which will not create shadows or cause a stroboscopic
effect.
SAFETY REGULATIONS FOR OPERATORS
Do not operate the machine without reading and understanding the contents of this user manual.
•
Regularly inspect safety covers ensuring that they are mounted properly and undamaged. Repair damaged
covers immediately or have them replaced with Jefferson Tools approved replacement parts.
•
Do not operate the maching with the safety cover removed.
•
Always use the machine for its intended purpose, do not modify the equipment for other uses.
•
Never use the machine at speeds higher than the manufacturers' recommended speed settings.
•
This equipment should only be repaired by fully-trained or approved engineers.
•
Stop the machine and unplug from the mains power supply before replacing the linishing belt.
•
Do not remove or interfere with safety devices such as safety covers and limit switches.
•
It is not recommended to work on the machine during a storm.