JEFBGSSTD
Bench Grinder Pedestal Stand
3.
4. Assembly Instructions:
This equipment requires assembly prior to use. It is important that you read the entire manual to become familiar with
the equipment before assembly.
Warning:
Use only bench grinders that are fully compatible with the
JEFBGSSTD Bench Grinder Pedestal Stand
.
Using bench grinders which do not fit this stand may result in harm or serious injury to the operator.
Before assembling your stand, be sure that you have all parts described in the Parts List.
1.
Set out all parts on a clear work surface prior to assembly.
2.
Mount the base to a heavy-duty block of wood which is larger than the pedestal stand base, or into a bed of
cement for safety and stability. A rubber mat should be placed between the base and the mounting surface to reduce
vibration. The mounting holes on the base are 3/8” in diameter. Insert appropriate screws (not included) through the
base and into a flat and secure surface.
Note:
The mounting surface must be able to support the weight of the Stand
as well as
the Grinder and work pieces
during use.
3.
Insert the column into the hole in the base. Insert a bolt into each hole in the base and tighten them firmly against
the column.
4.
Slide the work table into place on top of the column. Thread one bolt through each hole in the work table. Tighten
the bolts until they are firmly against the column.
5.
Make certain that all bolts are tightly in place and that the stand is secure.
6.
Secure the bench grinder to the work table with six appropriately sized nuts, bolts & washers
7.
Make sure that the pedestal stand and the bench grinder are safe & secure before using.
