Jeep GRAND CHEROKEE 2023, Руководство пользователя

Страница: 134 / 394

STARTING AND OPERATING 133
If either system is set when the vehicle speed is above
19 mph (30 km/h), the set speed shall be the current
speed of the vehicle.
NOTE:

Keeping your foot on the accelerator pedal can cause
the vehicle to continue to accelerate beyond the set
speed. If this occurs, the message “DRIVER OVERRIDE”
will display in the instrument cluster display.
 If you continue to accelerate beyond the set speed
while ACC is enabled, the system will not be controlling
the distance between your vehicle and the vehicle
ahead. The vehicle speed will only be determined by
the position of the accelerator pedal.
To Cancel
The following conditions cancel the ACC or Fixed Speed
Cruise Control systems:
 The brake pedal is applied

The CANC (cancel) button is pushed

The gear selector is removed from the DRIVE position

The Electronic Stability Control/Traction Control
System (ESC/TCS) activates

The vehicle parking brake is applied
 The Trailer Sway Control (TSC) activates

The braking temperature exceeds normal range
(overheated)
The following conditions will only cancel the ACC system:

Driver seat belt is unbuckled at low speeds

Driver door is opened at low speeds
To Turn Off
The system will turn off and erase the set speed in
memory if:

The Adaptive Cruise Control (ACC) on/off button is
pushed

Fixed Speed Cruise Control on/off button is pushed
 The ignition is placed in the OFF position

4WD Low is engaged
To Resume
If there is a set speed in memory, push the RES (resume)
button and remove your foot from the accelerator pedal.
The instrument cluster display will show the last set
speed.
Resume can be used at any speed above 19 mph
(30 km/h) when only Fixed Speed Cruise Control is
being used.
Resume can be used at any speed above 0 mph (0 km/h)
when ACC is active.
NOTE:

While in ACC mode, when the vehicle comes to a
complete stop longer than two seconds, the driver will
either have to push the RES (resume) button or press
the accelerator pedal to reengage the ACC system.

ACC cannot be resumed if there is a stationary vehicle
in front of your vehicle in close proximity.
WARNING!
The Resume function should only be used if traffic and
road conditions permit. Resuming a set speed that is
too high or too low for prevailing traffic and road
conditions could cause the vehicle to accelerate or
decelerate too sharply for safe operation. Failure to
follow these warnings can result in a collision and death
or serious personal injury.
23_W7_OM_EN_IN_t.book Page 133