Jeep Compass 2023, Руководство пользователя

Страница: 104 / 304

102 STARTING AND OPERATING
If the “SERVICE POWER STEERING” or “POWER STEERING
ASSIST OFF - SERVICE SYSTEM” message and a steering
wheel icon are displayed on the instrument cluster
display, it indicates that the vehicle needs to be taken to
an authorized dealer for service. It is likely the vehicle has
lost power steering assistance
Ú
page 70.
If the “POWER STEERING SYSTEM HOT - PERFORMANCE
MAY BE LIMITED” message and an icon are displayed on
the instrument cluster display, it indicates that extreme
steering maneuvers may have occurred, which caused an
over temperature condition in the electric power steering
system. You will lose power steering assistance
momentarily until the over temperature condition no
longer exists. Once driving conditions are safe, pull over
and let the vehicle idle for a few moments until the light
turns off
Ú
page 70.
NOTE:

Even if the power steering system is no longer opera -
tional, it is still possible to steer the vehicle. Under
these conditions there will be a substantial increase in
steering effort, especially at low speeds and during
parking maneuvers.
 If the condition persists, see an authorized dealer for
service.
STOP/START SYSTEM — IF EQUIPPED
The Stop/Start function is designed to reduce fuel
consumption. The system will stop the engine
automatically during a vehicle stop if the required
conditions are met. Releasing the brake pedal or pressing
the accelerator pedal will automatically restart the engine.
This vehicle has been upgraded with a heavy-duty starter,
enhanced battery, and other upgraded engine parts, to
handle the additional engine starts.
A
UTOSTOP
M
ODE
The Stop/Start feature is enabled after every normal
customer engine start. At that time, the system will go into
STOP/START READY.
To Activate The Autostop Mode, The Following Must Occur:
 The system must be in STOP/START READY state. A
“STOP/START READY” message will be displayed in the
instrument cluster display within the Stop/Start
section
Ú
page 70.

The vehicle must be completely stopped.

The gear selector must be in a forward gear and the
brake pedal pressed.
The engine will shut down, the tachometer will move to the
zero position, and the Stop/Start telltale will illuminate
indicating you are in Autostop. Customer settings will be
maintained upon return to an engine-running condition.
P
OSSIBLE
R
EASONS
T
HE
E
NGINE
D
OES
N
OT
A
UTOSTOP
Prior to engine shut down, the system will check many
safety and comfort conditions to see if they are fulfilled.
Detailed information about the operation of the Stop/Start
system may be viewed in the instrument cluster display
Stop/Start Screen. In the following situations the engine
will not stop:

Driver’s seat belt is not buckled.

Driver’s door is not closed.

Battery temperature is too warm or cold.
 Battery charge is low.

The vehicle is on a steep grade.

Cabin heating or cooling is in process and an accept -
able cabin temperature has not been achieved.

HVAC is set to full defrost mode at a high blower speed.

HVAC is set to MAX A/C.
 Engine has not reached normal operating temperature.

The transmission is not in a forward gear.

Hood is open.

Vehicle is in 4WD LOW transfer case mode.
 Brake pedal is not pressed with sufficient pressure.

Accelerator pedal input.

Engine temperature is too high.

5 mph (8 km/h) threshold has not been achieved from
previous Autostop.

Steering angle beyond threshold.
 Adaptive Cruise Control is on and speed is set.
It may be possible for the vehicle to be driven several
times without the Stop/Start system going into a STOP/
START READY state under more extreme conditions of the
items listed above.
23_MP_OM_EN_USC_t.book Page 102