Chapter
4
Fuel and exhaust systems
4-13
FITTING
TAB
\
SPACER
\
O-RINGS
RETAINER
12.10 Cutaway of quick-connect fitting showing
relationship of O-rings, spacer and retainer
QUICK-CONNECT
FUEL
FITTING
I
12.14 Once you've installed the new O-rings, spacer and
retainer, push the fuel line into the fitting until you hear a click
rings and a retainer (see illustration).
1 Every time you disconnect a quick-connect fitting, you must replace
the O-rings, spacer and retainer. These parts are available as a repair
kit through any dealer parts department.
12 To disconnect a quick connect fitting, simply pinch the t w o re-
tainer tabs together and pull the
apart. The retainer, O-rings and
spacer will come out of the fitting when you pull the fuel lines apart.
Discard these parts.
1 3 The replacement kit (O-rings, spacer and retainer) is installed on
a disposable plastic plug. To replace these parts, push the disposable
plug assembly into the quick connect fitting until you hear a "click"
sound (see illustration). Then grasp the end of the disposable plug and
it out of the fitting.
Push the fuel line into the refurbished quick-connect fitting until
you hear a "click" sound (see illustration).
1 5 Verify that the connection is secure by pulling firmly back on the
fuel line. It should be locked in place.
1 3 Throttle body
vehicles)
-
removal
and installation
Refer to illustrations 13.2, 13.3, 3.6 and 13.8
1
Detach the cable from the negative battery terminal.
2
Detach the vacuum hoses from the throttle body upper bonnet (see
illustration). Release the mounting clips and remove the upper bonnet.
3
Remove the three mounting nuts and lift off the lower bonnet (see
illustration).
REPLACEMENT
QUICK-CONNECT
DISPOSABLE PLUG
FITTING
12.13 The new O-rings, spacer and retainer are already
installed on a disposable plug
-
t o install them i n the
quick-connect fitting, insert the plug into the fitting until
you hear a click, then withdraw and discard the plug
I
13.3 Remove the mounting nuts, then detach the lower bonnet
13.2 Detach the vacuum hoses, release the mounting
clips and remove the upper bonnet
THROTTLE BODY
The Motor Manual Guy
Содержание cherokee 1989
