Jeep 2017 PATRIOT, Руководство пользователя

Страница: 143 / 252

Bulb Number
Rear Tail/Turn/Stop Lamp 3157
Backup Lamp W16W (921)
License Lamp W5W
Replacing Exterior Bulbs
Headlamps
1. Raise the hood and locate the connector
behind the headlamp.
2. Reach into engine compartment and pull
red lock out at connector.
3. Remove the green connector from the
back of the bulb by pulling straight back.
4. Twist the bulb to the left.
5. Pull bulb outward from assembly.
NOTE:
These are halogen bulbs. Take care not to
touch the bulb with your fingers. Body oils
from your fingers could cause excessive heat
buildup which reduces bulb life.
Fog Lamps
1. Access lamp through the lower fascia
cutout.
2. Remove electrical connector from bulb.
3. Remove bulb from housing.
CAUTION!
Do not touch the new bulb with your fin-
gers.
Oil contamination will severely
shorten bulb life. If the bulb comes in
contact with any oily surface, clean the
bulb with rubbing alcohol.
Rear Tail, Turn Signal And Backup Lamps
1. Raise the liftgate.
2. Remove the two push-pins from the tail-
lamp housing.
3. Grasp the taillamp and pull firmly to dis-
engage the light from the aperture panel.
4. Twist and remove socket from the light.
5. Remove bulb from socket and replace.
License Lamps
1. Use a screw driver to gently pry against
the side of the snap tab to remove the
lamp from the liftgate.
2. Rotate the socket 1/4 turn
counterclockwise.
3. Pull the bulb from the socket.
Center High-Mounted Stoplamp
This light is an LED assembly. See your au-
thorized dealer for replacement.
141