Adjust bumper pitch and height with the 5/8" bolts, or left and right with the frame side
bolts/slots. Check the operation of the tailgate, lower the bumper down if the gate hits
the top of the bumper.
Using the included 5/8" bolts, washers and nuts, reach up behind bumper and install into
slots from the outside in. Assemble in the orientation shown below, and be sure to do
this on both sides of the bumper. The swept back design of the bumper prohibits working
a lot room on this step, so exhibit patience!
*Alternatively, you can bolt the frame side
brackets onto the bumper before hoisting the whole assembly onto the frame. You can
pull the weather stripping out of the way to gain access to the upper bolts on the frame
side mounts. This method may take a time or two to get the alignment of everything
correct.
9.
8.
INSTALL ATION
