Part No. 960-100932R_Rev. A
© 2014, JCM American, Corporation
Part No. 960-100932R_Rev. A
© 2014, JCM American, Corporation
2
1 5
June, 2014
iVIZION PREVENTIVE MAINTENANCE INSTRUCTIONS
Instructions for performing a basic cleaning and maintenance of the JCM
iVIZION Banknote Validator are described below.
TOOLS AND EQUIPMENT
The following Tools and Equipment are required to properly clean your
iVIZION Banknote Validator:
– Two clean, dry lint-free cloths (or micro-fiber cloths)
– Cleaning solution: Warm water with a few added drops of mild, non-abrasive
detergent, such as liquid dishwashing soap)
– Canned compressed air, or a clean, moisture-free source of low pressure
(LP) air
– Medium-bristled Technician’s Cleaning Brush (JCM P/N 501-000097R),
nylon brush or acid brush
– Wood or plastic wand
– PS75-002 (or equivalent 12 Volt DC) Power Supply, or a suitable 24 Volt DC
Power Supply
–
JCM Tool Suite Installation Guide - Refer to the Support section at
www.jcmglobal.com
REFERENCE MANUALS
–
iVIZION Operations and Maintenance Manual - Refer to the Support section at
www.jcmglobal.com
NOTE: In the following procedures, be sure to use only WARM water with a
small amount of liquid dishwashing soap as a cleaning solution.
Alcohol, thinner, solvents, and citrus-based cleaners SHOULD
NEVER be used. These types of chemicals can cause “hazing” of the
imaging and optical sensors, and premature drying out of the Drive
Belts and Rollers.
NOTE: JCM Global does not recommend the use of any Cleaning Card on
the iVIZION Banknote Validator.
PERSONAL NOTES AND COMMENT AREA
Write any pertinent notes or comments regarding your particular installation
here.