June, 2014
June, 2014
Part No. 960-100932R_Rev. A
© 2014, JCM American, Corporation
1 6
1
Part No. 960-100932R_Rev. A
For the Americas & Oceania, E-mail: [email protected]
For the UK, Ireland, Europe, Africa, Russia & Middle East, E-mail: [email protected]
For Asia E-mail: [email protected]
JCM is a registered trademark of JCM American Corporation. All other product names
mentioned herein may be registered trademarks or trademarks of their respective companies.
Furthermore,
™
,
®
and
©
are not always mentioned in each case throughout this publication.
Operator’s Guide
© 2014, JCM American, Corporation
Operator’s Guide
iVIZION
®
Banknote Validator
Preventive Maintenance Instructions
This Guide describes procedures for the cleaning and maintenance of the
iVIZION
®
Banknote Validator. For additional information, refer to Section 2 of
the iVIZION Operation and Maintenance Manual (JCM P/N 960-100929R).
iVIZION REFERENCE DIAGRAMS
Figure 1 identifies the iVIZION
™
Validator Head, Transport Unit and Cash Box.
• Notes regarding iVIZION Components:
– Sensor locations are shown in yellow.
– Rollers are shown in blue.
– Drive Belts are shown in orange.
– Release levers are shown in green.
– Anti-stringing area is shown in red.
Figure 1
iVIZION Unit, Validator Head, Transport Unit and Cash Box
Typical iVIZION Components
iVIZION Validator Head
Typical iVIZION Unit
(fully assembled)
iVIZION Head and Transport Unit
iVIZION Transport Unit
(inverted)
iVIZION Cash Box
PERSONAL NOTES AND COMMENT AREA
Write any pertinent notes or comments regarding your particular installation
here.
