JCM EVOPROX, Руководство пользователя

Страница: 3 / 4

1247001-GB / 4.0
EVOPROX – STEELPROX-MOTION
3
CONNECTION
Connection is made through the wiring from the rear, which is connected directly to a
MOTION (+, -, L) decoder or a Wiegand (+, -, D0, D1, Control LED) or CONTROLLER-
6000 / C4+ station (+, -, CONTROLLER-6000).
Signal Cable colour
+ red
- black
L blue
D0 / CONTROLLER-6000
green
D1 white
Control LED
brown
CONFIGURATION
The proximity reader can be configured for work under Wiegand 26 or CONTROLLER-
6000 / C4+ or BUS-L protocol (with channels 1, 2, 3 or 4).
Use the button (4) to configure the reader’s operating mode.
WIEGAND WITH SITE CODE CONFIGURATION:
- Press the configuration button until the pilot light gives a series of flashing green
indications. When the button is released, the pilot light will remain red. In this operating
mode, the pilot light is controlled by the station through the LED Control line.
The format will be 8 bit site code + 16 bit code (maximum code value 65535).
WIEGAND WITHOUT SITE CODE CONFIGURATION:
- Press the configuration button until the LED flashes red. Once the button has been
released, the LED will remain lit red. The LED in this operating mode is controlled by the
control unit through the LED Control line.
The format will be 4 bit (zeros) + 20 bit code (maximum code value 1048575).
MOTION (BUS-L) CONFIGURATION:
- Press the configuration button until the pilot light gives a series of flashing green
indications and keep it pressed down until the number of long red signals corresponds to
the channel to be configured. For example, if you want to configure channel 2, release the
button after the second long signal.
CONTROLLER-6000 / C4+ CONFIGURATION:
- Press the configuration button until the pilot light gives a series of flashing green
indications and four long red indications and keep it pressed down until the number of
long green signals corresponds to the channel to be configured. For example, if you want
to configure channel 2, release the button after the second long green signal.
The procedure can be carried out as many times as required.
FACTORS INFLUENCING THE OPERATING DISTANCE
Orientation of the proximity key. Faulty reader supply. Interference on the 13.56 MHz
band.