JCM EVOPROX, Руководство пользователя

Страница: 2 / 4

1247001-GB / 4.0
EVOPROX – STEELPROX-MOTION
2
Proximity reader
TECHNICAL DATA
Reading system
By proximity
Operating range 5cm aprox
Power supply 12Vdc (9-21V)
Standby /operating consumption 68mA / 110mA (proximity to metals or between readers
affects consumption)
Compatibility MOTION and Myfare proximity
Operating frequency 13,56MHz
Wiring 6 wires (shielded-type recommended)
Cable section to 100/150/200m 0.22/0.35/0.5mm2 (category 5 recommended)
Watertight IP66
Operating temperature
-20ºC to +55ºC
Dimensions 84x75x14mm / 110X150X55mm (STEELPROX-MOTION)
Protocol Wiegand 26 with site code / Wiegand 26 without site code /
CONTROLLER-6000 / C4+ / BUS-L
Operations Read / Write MOTION cards and Reading of Myfare cards
OPERATING
By bringing the element close to the reading zone, the reader will send a signal to the
connected decoder and the pilot light will give a signal. The pilot light on the reader will
flash until confirmation is received from the receiver.
The equipment is able to operate with four different communications protocols. Once the
equipment is switched on, the LED will indicate the protocol to be configured in the
reader.
Protocol LED indications
Wiegand 26 with site code Flashing green
Wiegand 26 without site
code Flashing red
Motion (Bus-L) 1 / 2 / 3 or 4 green flashes corresponding to the channel
number configured
Controller-6000 / C4+ 1 / 2 / 3 or 4 red flashes corresponding to the channel
number configured
INSTALLATION
The reader consists of two elements: a compact box (1) with the front panel of plastic and
the wiring output on the rear panel, and a beauty sticker (2). It is designed for situate
directly on the wall or embedded. The fixing is made by means of two screws (3),
separated 60 mm between them (ideal separation if you want to embed it in one standard
switching box). The sticker must be situated on the 2 position of the figure, assuring that
the led (5) is visible across the sticker window. Before situating the sticker, screw and
configure the reader.
This reader can be installed into different types of surfaces, also into metallic surfaces, due
to the automatic adjustment of the frequency without the need of the installer intervention.