![background image](http://html2.mh-extra.com/html/jcm/dbv-series/dbv-series_operation-and-maintenance-manual_3535895064.webp)
P/N 960-000180R_Rev. 1 {EDP #233427}
© 2016, JAPAN CASH MACHINE CO., LTD.
6 - 1 0
Section 6
DBV® Series DBV-400 Banknote Validator
Calibration and Testing
This section provides Performance Testing
instructions for the DBV-400 Unit. This section
contains the following information:
•
Performance Test using a PC
•
Performance Test without a PC
Choose one (1) of the two (2) above Performance
Test Procedures by selecting the one related to the
particular circumstance desired.
Performance Test Using a PC
See “Workbench Tool Requirements With Refer-
ence Paper and a PC” on page 6-1 for the Tools and
Equipment interconnects necessary to perform a
DBV-400 Performance Test using a PC.
Table 6-2 lists the test items for the DBV-400 Per-
formance Test using a PC.
Perform the following steps to prepare the DBV-
400 for the Performance Test Procedures:
1. Remove electrical power from the DBV-400 Unit.
2. Set DS1 #8 to
ON
3. Apply electrical power to the DBV-400 Unit. The
Bezel LED will flash at a
Green
color rate when
the DBV-400 Unit is in the Performance Test
Stand-By Mode.
4. Connect the PC and the DBV-400 Unit together
using the recommended USB Cable.
5. Launch
the
“
JCM Tool Suite Standard Edition
”
Application. The “
JCM Tool Suite Standard
Edition
” Screen shown in Figure 6-46 will appear
when the application becomes active.
6. Click
the
“
Service Mode
” Pull-down Menu, and
select “
Performance Test
a
).
7. Performance Test will appear at the top of the
Main Screen (Figure 6-47).
Performance Tests
Table 6-2
Performance Test Items Using a PC and Test Menu Selections
Test Item
Test Menu Selection (On PC Screen)
Test Purpose
Feed Motor Normal Rotation
FEED_MOTOR_FWD_TEST
Speed Check while Normal Rotation
Feed Motor Reverse Rotation
FEED_MOTOR_REV_TEST
Speed Check while Reverse Rotation
Stacking
STACK_TEST
Stacking Mechanism Movement Check
at 3 seconds interval
Sensor Test
SENSOR_TEST
Each Sensor Performance Check
DIP Switch 1 Test
DIPSWITCH1_TEST
DIP Switch 1 Performance Check
DIP Switch 2 Test
DIPSWITCH2_TEST
DIP Switch 2 Performance Check
Bezel LED Test
LED_TEST
Bezel LED Performance Check
Performance Test Preparation
Figure 6-45
DS1 Switch Settings 1
ON
1
2
3
4
5
6
7
8
Figure 6-46
JCM Tool Suite Standard Edition
Figure 6-46
JCM Tool Suite Standard Edition
Screen/Pull-Down Menu 2
a
Figure 6-47
Main Screen