IGT Installation
1. Open the door of the machine.
2. Remove the 2 screws securing the
existing circuit board to the face plate
in the door of the machine (see
Figure 1).
3. Remove the lamps from the board.
4. Remove the yellow window cover.
5. Replace the yellow window
cover with the new JCM
SENTRY window cover.
6. If the lamp circuit board can be
removed, remove it.
Otherwise, thread the new
harness through the lamp
circuit board (see Figure 2).
7. Plug the new harness into the
JCM circuit board.
8. Position the circuit board
over the bosses on the bezel
(see Figure 3). If necessary,
use the 2 washers shown in
Fig. 4 to avoid
stressing the
board.
9. Screw in the
lamp cover (see Figure 1).
10. Run the harness across the door to the Bill Validator.
Figure 1
Figure 2
Figure 3
Figure 4