JCM GLOBAL Taiko PUB-7, Руководство пользователя

Страница: 4 / 20

Part No. 960-100919R_Rev. 1 © 2017 JCM American Corporation
4
March, 2017 JCM Training Overview Taiko™ Banknote Validator
TAIKO (PUB-7/11) DIP SWITCH DESIGNATIONS
The Taiko
™
Unit can be configured for various Communications Standards
and Protocols. Refer to the Taiko
™
Series (PUB-7/11) Operation and Mainte-
nance Manual (JAC Part No. 960-100175R), Tables 2-5, 2-6 and 2-7 for locat-
ing specific Connector Pin designations for either Serial/MDB, CC-Talk or
Pulse communication Protocols respectively.
Communications Protocols are selected via DIP Switch settings (Table 2).
Table 2 Typical Taiko DIP Switch Block Settings
SW No. DIP Switch Position Setting
1
OFF Normal operation
ON Test Mode (Setting Mode)
2
OFF 1-time scan (without validation retry)
ON 2-time scan mode (with validation retry)
3
OFF When Pulse I/F Mode, depends on enable/disable signal.
ON When Pulse I/F Mode, always enabled.
4
OFF 1 time Spin Mode (1 Drum Rotation Cycle)
ON 5 time Spin Mode (5 Drum Rotation Cycles - Anti-Fishing Prevention)
5
Serial I/F Mode (DIP Switch 8 OFF) Pulse I/F Mode (DIP Switch 8 ON)
6
7
8
OFF Serial I/F Mode (Selected by DIP Switches 6 and 7)
ON Pulse I/F Mode
NOTE: Always check the current Taiko™ Software Data Sheets to
verify the proper DIP Switch settings required for your particular Unit.
ON
OFF
SW5 PULSE WIDTH
OFF 50ms/300ms
ON 50ms/50ms
SW6 SW7 I/F Setting
OFF OFF ID-003
ON OFF ID-0D3
OFF ON
ID-0E3 (without
Encryption)
ON ON
ID-0E3 (with
Encryption)
SW6 SW7 Number of PULSE
OFF OFF 1 Dollar = 1 Pulse
OFF ON 1 Dollar = 4 Pulses
ON OFF 1 Dollar = 10 Pulses
ON ON 1 Dollar = 20 Pulses