jcb JCB-AG720, Инструкция по безопасности и эксплуатации

Страница: 10 / 28

JCB, SO53 3LE
www.JCBDIY.com
Customer Helpline 0333 0143092
Supports must be placed under the
workpiece near the line of cut and
near the edge of the workpiece on
both sides of the wheel.
6. Use extra caution when making
a “pocket cut” into existing
walls or other blind areas.
The
protruding wheel may cut gas or
water pipes, electrical wiring or
objects that can cause kickback.
Additional safety instructions
for sanding operations
Safety Warnings Specific for
Sanding Operations:
1. Do not use excessively
oversized sanding disc
paper. Follow manufacturer’s
recommendations, when selecting
sanding paper.
Larger sanding
paper extending beyond the
sanding pad presents a laceration
hazard and may cause snagging,
tearing of the disc or kickback.
Additional safety instructions
for polishing operations
Safety Warnings Specific for
Polishing Operations:
1. Do not allow any loose portion
of the polishing bonnet or its
attachment strings to spin freely.
Tuck away or trim any loose
attachment strings.
Loose and
spinning attachment strings can
entangle your fingers or snag on
the workpiece.
Additional safety instructions
for wire brushing operations
Safety Warnings Specific for
Wire Brushing Operations:
1. Be aware that wire bristles
are thrown by the brush even
during ordinary operation. Do not
overstress the wires by applying
excessive load to the brush.
The
wire bristles can easily penetrate
light clothing and/or skin.
2. If the use of a guard is
recommended for wire brushing,
do not allow any interference of
the wire wheel or brush with the
guard.
Wire wheel or brush may
expand in diameter due to work
load and centrifugal forces.
Additional safety rules for
angle grinder
WARNING: Make sure the
handle in the locked position
before start the angle grinder.
Rotating the handle is permitted
only in the switched off condition