Positec Australia Pty Limited
Unit 15, 23 Narabang Way, Belrose 2085 NSW Australia
www.jcb-tools.com
Customer Helpline 1300 889 028
off switch in the center position to
help prevent accidental start and
accidental battery discharge.
For forward rotation, (with chuck
pointed away from you) move the
lever to the far left. For reverse
rotation move the lever to the far right.
To activate switch lock move the lever
to the center off position.
CAUTION: Do not change
direction of rotation until the
tool comes to a complete stop.
Shifting during rotation of the
chuck can cause damage to the
tool.
4. USING THE LED LIGHT
The LED light allows you to keep
a clear view under less illuminated
circumstances. To turn on the light
simply press the on/off switch. When
you release the on/off switch, the light
will last for a few seconds then go out.
5. TOOL PROTECTION
SYSTEM
The tool and battery are equipped with
a protection system. When the LED
Light quickly flashes 3 seconds and
turn off, the system will automatically
cut off power to the tool to extend
battery life. The tool will automatically
stop during operation if the tool and/
or battery are placed under one of the
following conditions:
• Overloaded:
The tool is operated
in a manner that causes it to draw
an abnormally high current. In this
situation, release the Trigger Switch
on the tool and stop the application
that caused the tool to become
overloaded. Then pull the Trigger
Switch again to restart.
• Overheated:
Under the condition
above, if the tool does not start, the
Tool and Battery are overheated. In
this situation, let the Tool and Battery
cool before pulling the Trigger Switch
again.
• Low battery voltage:
The
remaining Battery capacity is too low
and the tool will not operate. In this
situation, remove and recharge the
Battery.
Содержание ID20LIBL2
Страница 2: ......