jcb 8026 CTS, Руководство оператора

Страница: 205 / 332

Routine Maintenance
Fluids, Lubricants and Capacities
187 187
9811/9950-1
Additives
The additives listed below are advertised as being suitable
for bringing the lubricity levels of kerosene/low sulphur
fuels up to those of diesel fuels. They must be used as
specified by your fuel supplier who will understand the
concentration level necessary.
Important: The lubricity wear scar diameter must not be
more than 460 microns, as tested on a high frequency
reciprocating rig at 60°C (140°F). Refer to ISO 12156-1.
– Elf 2S 1750. Dosage 1000-1500 ppm (0.1 - 0.15%),
specifically for Indian Superior Kerosene (SKO) but
may be applicable to other fuels.
– Lubrizol 539N. Dosage (on Swedish low sulphur fuel)
250 ppm.
– Paradyne 7505 (from Infineum). Dosage 500 ppm
(0.05%).
Note: These products are given as examples only. The
information is derived from the manufacturers data. The
products are not recommended or endorsed by JCB.
Service Requirements for use of B5 Biodiesel
– The engine oil must be a grade CH4 as minimum
specification.
– Do not leave unused B5 biodiesel in the fuel tank for
extended periods (top up each day).
– Make sure that 1 in 5 fuel tank fills use standard diesel
to EN590 specification, this will help to prevent
'gumming'.
– Make sure regular oil sampling is completed (look for
excessive unburnt fuel content, water or wear
particles.
– Change the engine oil and filter more frequently (as a
minimum half the recommended intervals), or as
indicated by oil sampling.
– Change the fuel filters more frequently (as a minimum
half the recommended intervals), or if there are
engine performance related issues.
– Make sure the fuel is stored correctly, care must be
taken to make sure no water enters the machine fuel
HE Services